Micronics Flow Meters are manufacturers and distributors of high quality portable flow meters. Our portable flow meter solutions are ultrasonic, clamp on and non-invasive, for closed pipe and open channel applications. This means no interruption to process and no downtime whilst the portable flow meter units are installed. Please explore our portable flow meters and related flow meter products via http://www.clamponflow.com
lamp-on flow and temperature sensors
Rate and totalised heat/energy demand
LCD with backlight
Fully adjustable for pipe sizes 22mm–115mm OD.
Simplified guide rail & sensor assembly – simple installation.
Clamp-on non-invasive & low install cost.
LCD with backlight – install & service information.
Integrated pulse and optional 4-20mA output – aM&T & BEM’s compatible.
|Measurement Technique: Transit time and PT100 Class B 4 wireTurn Down
Ratio: 200:01Heat Meter Standard: The Heat/Energy calculation is designed to comply with EN1434 section 6, third party certification
pending.Accuracy: +/-1-3% of flow reading for >0.3m/sFlow Velocity Range: 0.1 to 10m/s
Pipe Range: 25mm – 115mm OD
Water Temp Range: 0°C to 85°C
Temperature sensors: Clamp-on PT100 Class B 4 wire, range 0 to 85°C, resolution 0.1 °C
Output: KWh energy or volume flow pulse
External Power Supply: 12V-24V +/- 10% AC/DC at 7 watts
Electronics Enclosure: IP54
Input/Output Cable: 5m x 6 core for power in and data out
Dimensions: 250mm x 48mm x 90mm (electronics + guide rail)
Modbus Communication:Modbus RTU slave, RS485 serial link hardware layer.
Ultraflo U1000 HM.....
The new BTU/energy metering solution from Micronics. Simple, low cost, hot or chilled water energy measurement from outside the pipe. A smarter solution than in-line meters.
The U1000 HM is an ultrasonic clamp-on meter that uses ultrasound to measure flow rate and PT100 temperature sensors to measure flow and return temperatures. The U1000 HM displays energy rate and totalized energy with pulse output and Modbus communication, so it can be used as a standalone meter or as an integral part of a M&T or BEM's system.
Simple to install - clamp on to the pipe, set the pipe diameter and connect the power; no specialist skills and tools required and Modbus compatible.
600 S German Ln
Conway, AR 72034